home>Knowledge Center>Project Case>Wet & Dry Pulveriser Korea

Wet & Dry Pulveriser Korea

Wet And Dry PulveriserMain Characteristics Of Wet And Dry Pulveriser

• Unique and reliable
The dry and wet series pulverisers are very effective, as well as non-stop grinding process continuous.
• All contact parts are made of aluminum and stainless steel without corrosion
• Wet and dry pulveriser, it requires no v belts thus less friction loss.
• Increased production leads to a rapid return on investment
• All rotating parts are dynamic balanced for reduced vibration and performance.
• The technology of low temperature grinding so the original ingredient cannot destroy.

Operations Dry And Wet Pulveriser

The flow of material from the hopper is controlled by the side handle with ease to suit the load. Rotor rotates anti-clockwise direction. The beaters pass just beneath the ratchet teeth sleeve installed inside the top half of the crushing chamber, leaving a 3 mm line between the teeth and the tips of the leaflets that turn. This reduces the material trapped between the teeth of line as a sword with a scissors action in a 2880 RPM. After reducing the required size, the material will pass through the screen installed within the lower discharge end of the camera grinding. The air forces generated in the grinding chamber dust passes through the screen mounted on the lower discharge end of the grinding chamber, a filter associated with depression following delivery. (When the pulp wet grinding of materials, the balloon should not be used)

Open the lid of the chamber all grinding parts cleaned with a brush in a couple of minutes and the pulveriser is ready to crush below. If necessary, the grinding chamber can also be washed with water. Remove the cotton balloon and the screen, close the lid tightly and start the mill. Now pour a bucket or two of water in the hopper. The grinding parts washed with water and mop. Continue running the machine for a few minutes in the draft fresh air sucked into the grinder to dry. The mixer, when the worm was removed and reserved to eliminate the cur clip lock holding rotor pins. When the two edges are worm out, the sharpened on a stone grinder to be used as new. In addition, when fully alert out to the same weight and reassemble.

Application Of Dry And Wet Pulveriser

Pulveriser dry and wet milling are used exclusively for grinding in Korea, coriander, dried ginger, black pepper, turmeric and curry powder on a large scale. These spices are ground in an operation of the stage two / three, depending on the desired fineness, the breakdown of turmeric in a large screen holes for the first operation, and subsequent grinding fine on a screen made of holes fine for the second and third operation.

The Construction Of The Dry And Wet Pulveriser

Demolition wet and dry from heavy duty steel fabricated body. Polished aluminum chamber lined with serrated wear plate stainless steel, which protects the body against wear. The grinding is performed by a fixed set of best in a balanced rotor. A screen classifier forms the lower half of the grinding chamber.

Standard Accessories Dry And Wet Pulveriser

• A number of filters.
• Seven numbers on the screen a number of ampere meters Suitable three phase or single phase motor power {square cage (special powers can be accommodated): 110/220/380/415 Volts, 50/60 Hz, 1 / 3} phase.
• Three-meter cable suitable miniature circuit breaker as it is: 8828 3-meter cable and 3 pin is above as follows: 1,293 for a single phase electric motor or three-foot-beginners basic cable, and ammeter, for three-phase electric motor.

>> <<
goTop